logo
lalco
 
MELTING APPARATUS :
melting apparatus
MELTING POINT

CODE:242

DISCRIPTION:
MELTING POINT APPARATUS IS VERY USEFUL IN THE DETERMINATION OF THE MELTING POINT OF ANY SUBSTANCE IN SMALL QUANTITY UPTO 300 DEGREE C. IT CONSISTS OF AN ALLUMINIUM BLOCK WHICH ACCEPTS THREE CAPILLARY TUBES AND A MERCUTY THERMOMETER. THE BLOCK IS HEATED BY TWO ELEMENTS CLAMPED TO THE SIDES.

THE BUILT IN LAMP PROVIDES UNIFORM AND SHADOWLESS ILLUMINATION OF SAMPLE TUBE WHICH ARE VIWED THROUGH THE MAGNIFYING LENS AGAINST EITHER A DARK OR BRIGHT GROUND SELECTED BY ROTATING A KNOW TO THE REAR OF THE APPARATUS .

A BUILT IN A ROTARY THEOSTAT GIVES ACCURATE ADJUSTMENT OF THE RATE OF INCREASE OF TEMPERATURE AS MELTING POINT IS APPROACHED. BOTH THE HEATERS ARE KEPT 'ON' IN THE 'LOW' AS WELL AS 'HIGH' POSITION OF THE TOGGLE SWITCH, THUS ENSURING UNIFORM HEATING FROM BOTH SIDES OF THE BLOCK. A SECOND TOGGLE SWITCH ON THE RIGHT SIDE CONNECTS THE LAMP AND POWER INPUT TO THE APPARATUS.
.
 
coming soon
Stainless Steel Vacuum Filter Holder

CODE:244

DISCRIPTION:
Stainless Steel Vacuum Filter Holder 47mm, Stainless steel lid, Funnel base, clamp and Teflon coated filter support screen, silicon, Teflon sealing ting in lid. Filter diameter 47mm. Filtration area 12.4cm., Funnel cap 250ml. Max operating pressure for vacuum only. Sterilization autoclaving at upto 130d C or dry heat at 180d C, without mounted membrane filter but with filter flask .
 
coming soon
Membrane Filter Holder

CODE:245

DISCRIPTION:
Membrane Filter Holder Assembly with Membrane support, funnel, flask and clamp. Standard Joint Fitting .
CAT. NO. Membrane dia. (mm) Funnel cap. (ml) Flask Cap. (ml)
245/01 25 25 250
245/02 25 50 500
245/03 47 300 1000
 
coming soon
Filter Funnel Manifold

CODE:246

DISCRIPTION:
Filter Funnel Manifold for Sterility Test: This mechanism is to accept up to three 47mm, dia filter funnels. This mechanism can be connected in series to the same vacuum source to expand capacity if required. Large support base provides excellent stability each of the three vacuum outlets has leak-proof, two-way stopcock & a vent to accepts filter funnel through silicon rubber cork.
 
coming soon
Automatic Cut off Device for Distillation Unit

CODE:252

DISCRIPTION:
CAT. NO. STAGE
252/01 SINGLE
252/02 DOUBLE
252/03 TRIPLE
 
coming soon
Automatic Pipette washers

CODE:285

DISCRIPTION:
this unit has a large capacity of washing device. Especially recommended for serological, bacteriological clinical laboratories. It operates on a siphonic principal to send a continous flow of water over and through the pipettes. At a most normal pressure the water is completely changed in cycles of about one minute. Even at reduced pressure this washer operates efficiently. It consists of a stainless steel washing cylinder 22 height x 6 in diameter mounted on a base 10 diameter and a removable prpette holder which is of 5 diameters. The holder is completely made of stainless steel with a heavy mesh bottom. The cylinder has a inlet with a removable nose nipple for attaching to permanent drain if desired. This unit will accommodate pipettes upto 375mm in length.
 
coming soon
Rotary Microtome

CODE:290

DISCRIPTION:
Rotary Microtome as per Erma Japan, Complete with razor etc. with Box